Pro-Form 350 Specifiche Scaricare il pdf (Pagina 30)

5-2 EM-506 (N-07/03)

CINCINNATI INCORPORATED can provide many

other types of standard and special dies, some of which

are shown in Figure 5-4.

FIGURE 5-4 Types of dies

DIE SETS: Special care and precautions should be

taken when operating die sets with guide pins and

bushings.

Depending on the working height of the die set, the

full stroke return may cause the die set guide pins and

bushings to separate. Re-entry of the guide pins into

the bushings may be difficult, if not impossible. Each

die set application should be reviewed for this

condition.

CINCINNATI INCORPORATED recommends that

the working height of all die sets be such that the

bushings never leave the guide pins when the ram

makes a full up stroke.

TOOL INSTALLATION

To install the tooling, use the following procedure:

1. If the PROFORM is not already powered-up, turn

ON the main disconnect switch on the electrical

enclosure.

2. Depress the Main Drive START button on the

PROFORM PC Control. Hold the button until the

motor starts.

3. Log on to the PROFORM PC Control and verify that

the palmbuttons are enabled for SETUP mode. To

do this, press the OP STATION button in the

toolbar.

Click on the SETUP mode tab of the Operator

Stations dialog.

Ensure that the Station 1 checkbox is checked. If it is

not already checked, click on the white box to the

left of the “Station 1” label to enable it. Then press

1 2 ... 25 26 27 28 29 30 31 32 33 34 35 ... 73 74

Nessun commento

Pro-Form 350 Specifiche Pagina 30